Lightning Rods

Your locactin :Home>Products>Lightning Rods>Early Streamer Emission(ESE) Lightning Rod

Early Streamer Emission(ESE) Lightning Rod

External View

Early Streamer Emission(ESE) Lightning Rod

Product Introduction

DK8-BX10 Early Streamer Emission(ESE) Lightning Rod is designed according to IEC Standard High Voltage Testing Technology First Part: General Definition and Testing Requirement and GB 50057-2010 Design Specification of Building Lightning Protection. This lightning rod contains two parts: air termination(0.6 meter) and support accessory(1.2 meter), which can be combined into a integral through bolt. The Advance Time is 60μs. Under the same installation height, the radius of protection is larger then the ordinary lightning rod. With the advantages of light-weight and low load, it adopted stainless steel material, and can be install under hostile environment.


a. Accurate thunderbolt point.
b. Maintenance-free, do not need connect additional power.
c. Activate itself only when the thunderbolt forming, completely early discharge initially.

Item No。/Technical Parameter

Item No.
Discharge Current Capacity200kA (10/350μs)
Amplitude Attenuation Rate≥70%
Brupt Slope Damping Ratio≥48%
Advance Time60μs
Limiting Current Resistance Value≤3Ω
Grounding Resistance≤10Ω
Wind Resistance≤36m/s
Height1.8m(0.6m + 1.2m)
Down Conductorone or several round steel or the same sectional area steel flat.

Application Scope

Suitable for direct Lightning Protection of mobile communication base station, satellite station, warehouse, meteorological observatory, petrol station, airport station, military radar station, etc.

Flange Dimension

Early Streamer Emission(ESE) Lightning Rod

Installation Diagram

Early Streamer Emission(ESE) Lightning Rod

Products More
Hot Sales
快乐赛车单双 海南4+1走势图 快乐赛车官方开奖结果 快乐赛车计划群 快乐赛车计划下载 快乐飞艇怎么样倍投 内蒙古快3 快乐赛车冠军公式规律 快乐飞艇微信群 海南4+1走势图